Weboldalunk használatával jóváhagyja a cookie-k használatát a Cookie-kkal kapcsolatos irányelv értelmében.

BetaFPV ELRS Nano Receiver 2.4G

22.37 EUR
Model: beta_elrs_nanorx_2.4g
receiver color
no color


Nano receiver 2.4G version diagram as shown below.

Note: The firmware version of the Nano receiver and module manufactured by our company is ELRS 1.0.0-RC5 (the fifth test version before release);
ELRS Innovative team has officially released version 1.0.0. Based on the version, we have some updates:

  • 2.4G Nano TX Module supports 500Hz refresh rate;
  • Short press the button on the Nano module 3 times to get into the binding status.

Configuration & Bind 

ExpressLRS uses the Crossfire serial protocol (AKA CRSF protocol) to communicate between the receiver and the flight controller board. So make sure your flight controller board supports the CRSF serial protocol. Next, we use the flight controller with Betaflight firmware to show how to set up the CRSF protocol.

The connection between the ELRS Nano receiver and the FC board is shown below.


Antenna connector IPEX (u.FL)
Dimensions (Length * Width * Height) 12x19 mm
Radio frequency 2.4 GHz
Weight 0,7 g
Telemetry power 20dbm (100mW, 2.4G Version)
Frequency bands 2.4GHz ISM
Input voltage 5V

Package included

1 x BETAFPV ELRS Nano receiver

1 x BETAFPV T antenna

2 x Spare shrink tube

4 x 30awg silicon connection wires (1 black, 1 red, 1 white, 1 yellow)

1 x pin header 1x4

1 x Nano receiver user manual


1 rating
Write a review!
| 5 out of 5 Stars!
Verified purchase
Jó fajta betafpv vevő, előnye hogy az ufl csati jó feszes, egy könnyen nem fog kiugrani az antenna a helyéről

A good type of betafpv receiver, the advantage is that the ufl connector is tight, the antenna will not easily jump out of its place